Sir Bones gets hearing

Requirements:

• 2 Microphones
• some wire ( Used cat5 cable )
  
• drill
  
• glue gun
  

 First step is to remove the microphone.

Second step is to remove the circuit board. 

Next two holes are drilled in each side of the skull. 

Wire is soldered to the microphones, and then the microphones are glued into the skull.

The circuit board was a little too long for it to fit into the skull.  Luckily there was a portion of the circuit board that was unused.  After that was removed, the circuit board fitted inside the skull.

Everything fitted. Now on to finishing up the operation; Soldering the microphones back on to the circuit board.

A quick test by plugging the microphones into the computer, using Sound Recorder, and everything checks out.